Honeywell S89J1008 replaced by Honeywell S8910U1000. Honeywell S89J1008
Replaces many White-Rodgers, Robertshaw and Honeywell hot surface ignition models.
For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
For local (single rod) or remote (dual rod) rectification type flame sensing.
Contains easy-to-use instructions plus the accessories required to adapt the existing hot surface ignition module.
Provides one or three ignition trials (four-second or seven-second trials) per call for heat; prepurge of 32 seconds or less; up to 96 seconds between purge trial times.
Temperature range is -40 to +175 F (-40 to +79 C).
Product Specifications
Description Provide electronic control of direct hot surface ignition systems used on gas fired furnaces, boilers, and other heating appliances.
Ignition System Type Direct Hot Surface Ignition
Ignition Sequence The number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial.
Typical Gas Control VR8205, VR8305
Type of Gas Natural or LP
Flame Sense Single Rod or Two Rods
Ignition Source Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)
PrePurge 32 sec.
Ignition Trials To Lockout 1 or 3
Lockout Timing 4 sec. or 7 sec.
Ignition Trial Time (sec) 4 sec. or 7 sec.
Maximum Valve Load @ 24 Vac (Amps) 2A
Typical Ignition Hardware Norton 201, Norton 271, Q354
Dimensions (in.) 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long
Dimensions (mm) 133 mm high x 103 mm wide x 49 mm deep
Electrical Ratings 24 Vac
Frequency 60 Hz
Maximum Ambient Temperature (F) -40 F to +175 F
Maximum Ambient Temperature (C) -40 C to +79 C
Approvals, Canadian Standards Association Design Certified
Tradeline Value Super Tradeline
Between Trial Time (sec) (2) 96 sec.- 3 trial mode only
Flame Failure Response Time (sec) 1.5 sec.
REPLACES: Honeywell S89J1008 |
|
Cart is empty